Permanent Magnet DC Generators

443541 Permanent Magnet DC Generator

     Current Rating for the # 443541

            3 A - Continuous Duty

            3.3 A - 60 minutes

            4 A - 30 minutes

           10 A - 5 minutes

         Scroll to bottom of page to view performance curves.

• Magnets: Two high-energy saturated C8 ceramic magnets.
• Shaft: Steel 12.7mm (1/2") diameter, 40mm length, with 1mm full-length flat.
• Armature: 16-slot armature 52mm diameter wound with AWG25 magnet wire (fusing current:24 amps).
• Brushes: Extra-long 8x14mm brush assemblies including spring, pigtail, and cap - replacement stock no. 443732
• Bearings: Two double-sealed 32mm OD ball bearings - replacement stock no. 171110
• Rotation: Either direction - The red output wire is positive for clockwise rotation from the shaft end.
• Speed: Zero to 5,000 rpm - generates at all speeds- depends on load.
  Mounting: Four 6mm holes on the front or rear end caps, or by hose clamps on the magnet drum.
• Weight: 4.2Kg (9.2lb) Shipping weight 4.6Kg (10lb), dimensions 150x150x300mm (6x6x12in).
• Resistance: Internal resistance 7.7 ohms. Inductance 16mH.
• Performance: See performance curves below
• Maximum charging current is 10A (see run times below) If you exceed these specifications the generator will overheat.
• Generator is not weather proof and needs to be enclosed if outside.

Generators are non- returnable once

installed and connected to a power supply.

If you receive a generator that is damaged in shipping, please notify us before you install the generator in your application.

More about Startup Torque

DC Generator (443541): $249.00